*Lycaon Swift is equipped with convertible powertrain in hub version & belt version. This listing is about the Lycaon Swift-Hub. Click to check out the Lycaon Swift-Belt.
8 ply Canadian maple + 1 ply fiber glass Dropped Deck + W-Concave
Dimension
36.6'' / 93 cm (Length) 9.8'' / 25 cm (Max. Width) 0.6'' / 1.5 cm (Thickness)
Ground Clearance
3.5'' / 9.2cm
Wheelbase
31'' / 79cm
Weight
19.6 lbs / 8.9 kg
Max Load
330 lbs / 150 kg
Wheels
78A 90mm
Trucks
7''
Bearing
608RS ABEC-11
Charging Time
4-5 Hours
IP Rating
IP54 (Prevent against daily dust and splash)
Data of top speed, range, and hill-climbing are based on a rider weighing 155lbs traveling across the downtown floor and could be impacted by riding style, weight, terrain, and weather.
Other specs are typical values for your reference only. LycaonBoard shall be entitled to change without notice for any technological innovations.
Lycaon Swift Details
Lycaon Swift-Shift
The board and the remote are already paired for sale, if you want to change the drive motors or other settings, please follow the steps below to do the re-connecting.
Keep both remote and board powered off.
Hold the power button of them both at the same time until the remote displays "PAIRED OK".
Scroll the throttle to select options of setting, and press the remote power button to confirm.
If you select HUB motors, you’ll go through the following settings: UNIT SYSTEM - Select from 【KM/H KM】 and 【MPH MILE】. MOTOR TYPE - Select from【HUB】and 【BELT】 WHEEL DIAMETER - Select the actual size of wheels you are going to use from【80-200】. MOTOR POLE PAIRS – Select 【11】.
If you select BELT motors, you’ll go through the following settings: UNIT SYSTEM - Select from 【KM/H KM】 and 【MPH MILE】. MOTOR TYPE - Select from【HUB】and 【BELT】 WHEEL DIAMETER - Select the actual size of wheels you are going to use from【80-200】. DRIVE RATIO – Select【2.6】for 36T pulley, 【2.9】for 40T pulley.(Tooth/14，eg: 40/14≈2.9) MOTOR POLE PAIRS – Select 【7】.
Leave the remote on and restart the board. Once the board is on, press the board power button quickly and immediately 5 times. The board will enter into the auto-learning process. If fails, turn off the board with the remote on and try again.
The auto-learning process will last about 60 seconds. Do NOT move or touch the board during the auto-learning.
When the auto-learning finished, turn off the remote then the board will accordingly power off.
Use remote only to power on both remote and board. Now, you are good to go.
